TM 5-3895-369-14
(42)
(43)
(44)
(45)
Remove nut (53) washer (54), governor
shaft (55), flyweight holder assembly (57),
washer (58). and shim (59).
Install correct size shim (59).
Install washer (58), flyweight holder
assembly (57) and governor shaft (55).
Repeat steps (39) to (41).
(46)
Determine starting stroke adjustment as
follows:
(a)
Install block gage with two screws.
Ensure block gage groove faces
governor lever.
(b)
Measure starting stroke adjustment at
position E. If measurement not within
limits, perform steps (46) (c)
to (46) (h). if measurement is within
limits, go to step (44).
5 - 2 6 0
