TM 5-3895-369-14
(29) Determine plunger assembly adjustment
as follows:
(a) Remove shim (84).
Ensure to align plunger groove with knock
pin in cam plate or damage to injection
pump may result.
(b)
(c)
(d)
(e)
(f)
(g)
Install plunger assembly (70),
distributor head (67) and four
screws (66). Tighten screws 86 to 121
lb-in. (10 - 14 N•m).
Rotate drive shaft (100) until
plunger (79) reaches bottom dead
center.
Measure plunger assembly (70) at
position B.
Remove four screws (66), distributor
head (67) and plunger assembly (70).
Install correct size shim (84) to get
correct plunger assembly measurement.
Remove dial gage.
5-256
