TM 5-3895-369-14
OBTAIN ALL COMPONENTS REQUIRED TO FABRICATE DESIRED HOSE ASSEMBLY (TABLE F-5).
1.
USE A FINE TOOTHED HACKSAW OR SUITABLE CUTTING DEVICE, AND CUT HOSE TO INDICATED LENGTH.
2.
SLIDE FOUR CLAMPS OVER HOSE.
3.
PLACE FITTING A IN VISE.
4.
SLIDE AND TURN HOSE ON FITTING A UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN.
5.
PLACE FITTING B IN VISE.
6.
SLIDE AND TURN HOSE ON FITTING B UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN.
7.
SLIDE CLAMPS DOWN TO FITTING. LEAVE ABOUT 1/2 INCH BETWEEN CLAMPS AND BETWEEN FITTING AND END CLAMP.
8.
TIGHTEN CLAMPS.
9.
Figure F-11. Additive Solution Hose.
Table F-4. Additive Solution Hose Assemblies and Components.
Fitting
Fitting
Clamp
Bulk Hose
Cutoff Length
Hose Assembly
A
B
C
Part Number
Inches (mm)
Manufacturer's
Part Number
J213
FAB250F
113 (2870)
FAB250F
47HW
47HW-2-1/2-AB
250F-AE250F-113
ST30
J213
FAB250F
47HW
128 (2870)
47HW-2-1/2-AB
250f-AB250F-128
F-12