TM 5-3895-369-14
NOTES:
OBTAIN ENOUGH 3/8 IN. (10 MM) THICK RUBBER STOCK, PN 47-71760-24, TO FABRICATE ENGINE MOUNT PAD.
1.
CUT A ROUND 2-1/2 IN. (102 MM) DIAMETER PAD FROM RUBBER STOCK AS INDICATED.
2.
CUT 11/16 IN. (17 MM) DIAMETER HOLE IN CENTER OF PAD AS INDICATED.
3.
Figure F-14. Front Engine Mount Pad.
NOTES
OBTAIN ENOUGH 3/8 IN. (10 MM) THICK RUBBER STOCK, PN 47-71760-24, TO FABRICATE ENGINE MOUNT PAD.
1.
CUT 4 IN. BY 4-3/4 IN. (102 MM BY 121 MM) REAR ENGINE MOUNT PAD FROM RUBBER STOCK AS INDICATED.
2.
CUT TWO 9/16 IN. (14 MM) DIAMETER HOLES IN PAD AS INDICATED.
3.
Figure F-15. Rear Engine Mount Pad.
F-14