TM 5-3895-369-14
NOTES
1.
OBTAIN ENOUGH BULK HOSE, PN 4M2T, TO FABRICATE LUBRICATION HOSE.
2.
USE A FINE TOOTHED HACKSAW OR SUITABLE CUTTING DEVICE, AND CUT HOSE TO INDICATED LENGTH.
3.
SLIDE FERRULES C ON HOSE AS NECESSARY.
4.
PLACE FITTING A IN VISE.
5.
SLIDE AND TURN HOSE ON FITTING A UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN.
6.
PLACE FITTING B IN VISE.
7.
SLIDE AND TURN HOSE ON FITTING B UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN.
8.
SLIDE ONE EACH FERRULE TO END OF HOSE UNTIL THEY ARE AGAINST FITTINGS A AND B.
CRIMP FERRULES TO HOSE.
9.
Figure F-16. Clutch Lubrication Hose.
F-15
