TM 5-3895-359-14&P
Fig. 22 Setting Calibrator Stroke Counter
2.
Place the injector seat J 22410-226 into the
permanent seat (cradle handle in vertical position).
Fig. 24 Removing or Installing Plunger Follower,
Clamp the injector into position by operating the air
Plunger and Spring
valve.
NOTE:
3. Pull the injector rack out to the no-fuel position.
Make sure the counter (Fig. 22) on
the calibrator is preset at 1000
4. Turn on the main power control circuit switch. Then
strokes. If for any reason this setting
start the calibrator by turning on the motor starter switch.
has been altered, reset the counter to
1000 strokes by twisting the cover
NOTE:
release button to the left and hold
The low oil pressure warning buzzer
the reset lever in the full up position
will
while setting the numbered wheels.
Close the cover.
Refer to the
calibrator instruction booklet for
further information.
Fig. 25. Removing Injector Nut
Fig. 23. Removing or Installing Filter Cap
10-3-14
