TM 5-3895-342-12
b. Cleaning and Inspection.
(1) Clean all parts with a cleaning solvent.
b. Cleaning and Inspection.
(2) Inspect all parts for wear or damage.
(1) Clean all parts with a cleaning solvent.
Replace worn or damaged parts.
(2) Inspect all parts for wear or damage.
c. Installation. Install the choke control in
Replace worn or damaged parts.
reverse of the instructions on figure 4-32.
c. Installation. Install the ignition switch in
4-39. Governor Control
reverse of the instructions on figure 4-34.
a. Removal. Remove the governor control as
4-41. Start Switch
instructed on figure 4-33.
a. Removal. Remove the start switch as
instructed on figure 4-34.
b. Cleaning and Inspection.
(1) Clean all parts with a cleaning solvent.
(2) Inspect all parts for wear or damage.
Replace worn or damaged parts.
c. Installation. Install the start switch in
reverse of the instructions on figure 4-34.
4-42. Fuel Level Gage
a. Removal. Remove the fuel level gage as
instructed on figure 4-34.
b. Cleaning and Inspection.
(1) Clean all parts with a cleaning solvent.
(2) Inspect all parts for wear or damage.
Replace worn or damaged parts.
c. Installation. Install the fuel level gage in
1. DISCONNECT CHAIN AT VARIABLE SPEED
reverse of the instructions on figure 4-34.
LEVER AND AT CONTROL.
4-43. Oil Pressure Gage
2. REMOVE LOCKNUT AND CONTROL.
a. Removal. Remove the oil pressure gage as
ME 3895-342-12/4-33 C1
instructed on figure 4-34.
Figure 4-33. Governor control removal.
b. Cleaning and Inspection.
b. Cleaning and Inspection
(1) Clean all parts with a cleaning solvent.
(2) Inspect all parts for wear or damage.
(1) Clean all parts with a cleaning solvent.
Replace worn or damaged parts.
(2) Inspect all parts for wear or damage.
c. Installation. Install oil pressure gage in
Replace worn or damaged parts.
c. Installation. Install the governor control in
reverse of the instructions on figure 4-34.
reverse of the instructions on figure 4-33.
4-44. Ammeter
4-40. Ignition Switch
a.
Removal.
Remove the ammeter as
a. Removal. Remove the ignition switch as
instructed on figure 4-34.
b. Cleaning and Inspection.
instructed on figure 4-34.
(1) Clean all parts with a cleaning solvent.
(2) Inspect all parts for wear or damage.
Replace worn or damaged parts.
of the instructions on figure 4-34.
4-45. Hour Meter-Tachometer
a.
Removal.
Remove the hour meter-
tachometer as instructed on figure 4-34.
b. Cleaning and Inspection.
(1) Clean all parts with a cleaning solvent.
(2) Inspect all parts for wear or damage.
Replace worn or damaged parts.
c. Installation.
Install the hour meter-
tachometer on reverse of the instructions
on figure 4-34.
Figure 4-34. Meters and gages removal.
4-20
Change 1
