TM 5-3895-370-34
Figure 2-25. Disengage/Engage Drive Coupling.
b. Installation.
(1) Position the main clutch assembly (4, fig. 2-26) in vehicle and slide to the rear and engage the drive coupling (8)
with right angle gear box (2, fig. 2-25).
(2) Line up the mounting holes for the three bearing blocks (1 and 9, fig. 2-26) and install the mounting bolts and nuts
(15 and 20, fig. 2-24) and tighten securely.
(3) Line up the marks on the clutch shaft (4, fig. 2-23) and rear U-joint (3) and assemble U-joint to the shaft, a lining
the roll pin holes on both ends of the U-joint.
(4) Install roll pins (2) (roll pins should only be replaced if they were damaged during removal).
(5) Install setscrew (6) and lockwire (7) on forward U-joint (5) (if removed).
(6) Install fork assembly (16, fig. 2-24) and retaining rings (4).
(7) Install shaft (3) and tighten setscrew (17) and bolts and washers (14).
2-40
