TM 5-3895-372-34
2-15. Main Clutch.
a. Removal.
(2) Clean, polish, and lubricate drive shaft (4, fig. 2-23) just forward of U-joint (3).
(3) Mark the rear U-joint (3) and drive shaft (4) on both ends of the U-joint to aid in reassemble. The U-joint and
shafts are line drilled for roll pins during initial assembly and can only be assembled in one position.
(4) Remove two roll pins (2) and grease fitting from U-joint cross.
Figure 2-22. Remove/Install Access Covers.
2-37