Figure F-11. Additive Solution Hose

Table F-3. Fuel Hose Assemblies and Components

Figure F-12. Groundspeed Sensor Wiper

TM-5-3895-369-14 Mixer Rotary Tiller Manual
Page Navigation
1261

F-12. ADDITIVE TM 5-3895-369-14 1. 2. 3. 4. 5. 6. 7. 8. OBTAIN ALL COMPONENTS REQUIRED TO FABRICATE DESIRED HOSE ASSEMBLY (TABLE F-5). USE A FINE TOOTHED HACKSAW OR SUITABLE CUTTING DEVICE, AND CUT HOSE TO INDICATED LENGTH. SLIDE FOUR CLAMPS OVER HOSE. PLACE FITTING A IN VISE. SLIDE AND TURN HOSE ON FITTING A UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN. PLACE FITTING B IN VISE. SLIDE AND TURN HOSE ON FITTING B UNTIL HOSE BOTTOMS AGAINST FITTING. BACK OFF 1/4 TURN. SLIDE CLAMPS DOWN TO FITTING. LEAVE ABOUT 1/2 INCH BETWEEN CLAMPS AND BETWEEN FITTING AND END CLAMP. 9. TIGHTEN CLAMPS. Figure F-11. Additive Solution Hose. Table F-4. Additive Solution Hose Assemblies and Components. Hose Assembly Manufacturer’s Part Number Bulk Hose Cutoff Length Fitting Fitting Clamp Part Number Inches (mm) A B C 47HW-2-1/2-AB 47HW 113 (2870) FAB250F FAB250F J213 250F-AE250F-113 47HW-2-1/2-AB 47HW 128 (2870) FAB250F ST30 J213 250f-AB250F-128 F-12

Privacy Statement
Press Release
Contact