F-11. ADDITIVE
TM 5-3895-369-14
Table F-3. Fuel Hose Assemblies and Components.
Hose Assembly
Manufacturer’s
Part Number
Bulk Hose
Cutoff Length
Fitting
Fitting
Ferrule
Part Number
Inches (mm)
A
B
C
6LOLA-6RFSX-
6LOLA
24 (610)
6LOC-6RFSX
6LOC-6RFSX
N/A
6RFSX-24
6LOLA-6FSX-
6LOLA
27 (686)
6SFX-27
284-0610
284-0610
N/A
NOTES.
1.
2.
3.
4.
5.
6.
7.
8.
9.
OBTAIN ALL COMPONENTS REQUIRED TO FABRICATE THE SUCTION HOSE ASSEMBLY.
USE A FINE TOOTHED HACKSAW OR SUITABLE CUTTING DEVICE, AND CUT HOSE TO INDICATED LENGTH.
SLIDE FOUR CLAMPS OVER HOSE.
PLACE FITTING A IN VISE.
SLIDE AND TURN HOSE ON FITTING A UNTIL HOSE BOTTOMS AGAINST FITTING.
BACK OFF 1/4 TURN.
PLACE FITTING B IN VISE.
SLIDE AND TURN HOSE ON FITTING B UNTIL HOSE BOTTOMS AGAINST FITTING.
BACK OFF 1/4 TURN.
SLIDE CLAMPS DOWN TO FITTING.
LEAVE ABOUT 1/2 INCH BETWEEN CLAMPS AND BETWEEN FITTING AND END CLAMP.
TIGHTEN CLAMPS.
Figure F-10. Additive Suction Hose.
F-11
