TM 5-3895-359-14&P
REPLACING SPOOL SEALS IN CONTROL VALVE
For the purpose of these instructions, we shall consider
the control handle side of the valve as the front end, and
the opposite end as the back end.
FIGURE 3
1. Remove the bonnet assembly (1) by removing
fillister head screws (2).
2. Remove spool assembly screw (3), spool collar
(4), lockwasher (5), collar (6) and spring (7). Be
sure to observe the order in which these parts
are removed to insure proper reinstallation.
3. Disconnect handle from spool by removing
cotter pin (8) and handle pin (9). Let handle
swing free of spool.
8-2
