TM 5-3895-342-34
c.
Cleaning, Inspection and Repair.
(3) Remove gib key from reduction pulley,
and unwind cable from reduction pulley far enough to
(1) Clean all parts with cleaning solvent.
permit sliding pulley off of shaft and placing pulley out of
(2) Inspect all parts for wear and damage.
the way on top of mixer.
Repair or replace worn and damaged parts.
d. Reassembly. Reassemble the skip vibrator
(4) Remove gib key from right-hand winding
drum, pull skip cable off drum as far as possible and
assembly in reverse of numerical sequence as
then remove capscrew, lockwasher and cut washer
illustrated in figure 6-1.
securing cable to drum.
e. Installation.
Install skip vibrator assembly
b. Cleaning, Inspection and Repair.
(1) Clean cable with cleaning solvent.
(2) Inspect cable for wear and damage.
6-4. Skip Cable
Replace excessively worn or damaged cable.
a. Removal.
c. Installation. Install skip cable in reverse of
(1) Lower skip to the ground.
instructions in subparagraph a above.
(2) Remove gib key from outer end of left-
hand winding drum, pull cable off winding drum as far as
possible, then remove capscrew, lock-washer and cut
washer securing cable to winding drum.
Section II. SKIP HOIST ASSEMBLY
washers securing cable to reduction pulley.
6-5. General
(4) Drive out shaft, remove two bolts and
The skip hoist assembly consists of a reduction pulley,
lockwashers from each bearing plate and remove
left-hand and right-hand winding drums, shaft, and cable.
bearings.
b. Cleaning, Inspection and Repair.
6-6. Reduction Pulley, Winding Drums, Bearings and
(1) Clean all parts with a cleaning solvent.
Shaft
(2) Inspect all parts for wear and damage.
a. Removal
Repair or replace worn and damaged parts.
(1) Remove skip cable (para 6-4).
c. Installation. Install reduction pulley, winding
(2) Slide left and right-hand winding drums off
drums, bearings and shaft in reverse of instructions in
of shaft.
subparagraph a above.
(3) Unwind cable from reduction pulley as far
as possible, then remove two capscrews and lock-
6-3
