TM 5-3895-342-34
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
AND AUXILIARIES
2-8. Clutch Housing Assembly
a. Removal
(1) Remove pump belt and drive hoist belt as
instructed in TM 5-3895-342-12.
(2) Remove motor sheave.
(3) Remove oil level plug and drain oil from
housing.
securing clutch housing to engine and remove housing
and gasket.
b. Installation. Install clutch housing assembly in
reverse of instructions in subparagraph a above.
2-9. Engine Assembly
a. Removal
(1) Remove pump belt and hoist drive belts
as instructed in TM 5-3895-342-12
(2) Remove fuel tank as instructed in TM 5-
3895-342-12.
(3) Disconnect battery cable from start switch
on engine.
(4) Disconnect engine ground wire from
decking.
Figure 2-1. Discharge spout assembly removal.
securing engine spacer plates to deck.
(6) Lift engine assembly off mixer with
b. Installation. Install discharge spout assembly
suitable lifting device.
b. Installation. Install engine assembly in reverse
of instructions in subparagraph a above.
2-12. Skip
a. Removal
2-10. Water Tank
(1) Lower skip to ground.
a. Removal
(2} Disconnect cable from left hand winding
(1) Drain all water from tank.
drum and pull cable free of skip.
(2) Disconnect hose at tank.
(3) Disconnect vibrator cable from underside
of skip.
securing tank to support angles. Lift tank off mixer.
b. Installation. Install water tank in reverse of
holding skip pillowblocks to mixer and remove skip and
instructions in subparagraph a above.
pillowblocks.
b. Installation.
Install skip in reverse of
2-11. Discharge Spout Assembly
instructions in subparagraph a above.
a. Removal.
Remove discharge
spout
as
2-13. Skip Vibrator Assembly
a. Removal
2-3