TM 5-3895-342-34
possible in the same direction. While holding both parts
(3) Hook the governor lever tension spring
in this position, screw the ball joint onto the control rod
into the fifth hole (from the bottom) in the governor lever
and adjust the spring tension by means of the adjusting
until the right angle stud on the ball it fitting registers with
screw connected to the spring to run 1725 revolutions
the hole in the lever, then screw fitting in two more turns.
per minute without load. The speed at full load will then
(2) Insert ball joint stud into the hole in
be approximately 1600 revolutions per minute.
governor lever, assemble and tighten locknuts. With the
governor lever pushed toward the carburetor as far as it
will go, there should be a 1/ 16 inch clearance between
3-3. Carburetor
the throttle lever and the stop pin on the carburetor.
a.
Removal Remove the carburetor (TM 5-3895-
342-12).
3-3
