TM 5-3895-342-34
c.
Cleaning, Inspection and Repair.
KEY to fig. 3-3:
(1) Clean all parts with cleaning solvent.
1. Gasket
23.
Screw and washer
(2) Inspect all parts for wear or damage.
2. Screw
24.
Plate, choke
Repair or replace worn or damaged parts.
d. Reassembly. Reassemble the carburetor in
3. Gasket
25.
Shaft, choke
4. Jet, idle
26.
Nut
reverse of numerical sequence as illustrated in figure 3-
5. Axle, float
27.
Lockwasher
3.
6. Float and hinge ay
28.
Sprig
e. Installation. Install the carburetor (TM 5-3895-
7. Valve and seat: fuel
29.
Screw
342-12).
8. Washer
30.
Lever choke
f.
Adjustment. Adjust the carburetor (TM 5-3895-
9. Plug, 1/8 in.
31.
Screw
342-12)
10. Screw and washer
32.
Bracket, choke
11. Plate, throttle
33.
Retainer
3-4. Magneto
12. Shift and stop lever
34.
Seal
a. Removal. Remove the magneto (TM 5-3895-
13. Screw
35.
Nut
342-12).
14. Bushing
36.
Screw
b. Disassembly. Disassemble the magneto in
15. Seal
37.
Clip
numerical sequence as illustrated in figure 3-4.
16. Retain
38.
Plug
17. Needle: idle adj
39.
Plug
i8. Sprig
40.
Plug
19. Venturi
41.
Washer, fiber
20. Jet, well vent
42.
Jet, main
21. Jet, discharge
43.
Washer, fiber
22. Washer, fiber
44.
Bowl, fuel
3-5
