TM 5-3895-342-34
(1) Lower skip to ground.
(2) Remove three capscrews holding sheave
(2) Disconnect vibrator cable from underside
to assembly.
of skip.
(3) Remove cotter pin from tension rod and
(3) Disengage vibrator cable from bracket
disengage tension rod from gear case.
below skip. Remove two bolts, nuts and lock-washers
(4) Remove pillowblock.
holding skip vibrator assembly to mixer.
(5) Remove oil level plug from gear case and
b.
Installation. Install skip vibrator assembly in
drain.
reverse of instructions in subparagraph a above.
(6) Remove eight bolts, nuts and lockwashers
holding cover to case and remove case and gasket.
b. Installation.
Install reduction gear case
2-14. Drive and Hoist Assembly
assembly in reverse of instructions in subparagraph a
a.
Removal
above.
(1) Remove skip vibrator assembly (para 2-
2).
2-16. Drum
(2) Remove hoist cable (TM 5-3895-342-12).
a. Removal
(3) Remove engine (para 2-9).
(1) Lower skip to the ground.
(4) Remove battery box (TM 5-3895-342-12).
(2) Remove discharge spout assembly (para
(5) Remove remaining two bolts, nuts and
lockwashers securing side support to deck.
(3) Remove eight bolt, nuts and lockwashers
(6) Remove two bolts, nuts and lockwashers
holding ladder to frame and remove ladder.
holding bottom of side support to lower frame.
(4) Remove eight bolt, nuts and lockwasher
(7) Remove two nuts and washers securing
holding right guard to frame and remove guard.
side support to left upright.
(5) Remove four bolts, nuts and lockwashers
(8) Remove two bolts, nuts and lockwashers
holding left guard to frame and remove guard.
securing pillowblock on each end of drive and hoist
(6) Remove four bolt, nuts and lockwashers
assembly to frame.
holding each rear upright to the upper frame.
(9) Remove bottom nut from tension rod and
(7) Remove two bolts, nuts and lockwashers
lift rod out of frame.
holding each front upright to upper frame.
(10) Remove cotter pi from back side of skip
(8) Disconnect hose from pump to upped
clutch shifter yoke, remove cotter pin from yoke rod at
frame at upper frame end.
frame end, slide rod out and remove yoke.
(9) Disconnect hose from three-way valve to
(11) Remove nut and washer securing brake
drum at three-way valve end.
hold-own rod to frame.
(10) Provide sufficient slack in skip cable to
(12) Remove cotter pin from rod holding brake
permit lifting water tank and upper frame off and setting it
band to brake linkage and disengage rod from linkage.
to one side of mixer.
(13) Lift drive and hoist assembly out of mixer
(11) Remove section of water pipe that
with suitable lifting device.
b. Installation. Install drive and hoist assembly in
protrudes into drum.
(12) Use suitable lifting device to hoist drum
reverse of instructions in subparagraph a above.
out of mixer.
b. Installation.
Install drum in reverse of
2-15. Reduction Gear Case. Assembly
instructions in subparagraph a above.
a. Removal.
(1) Remove drive and hoist assembly (para 2-
4).
2-4
