TM 5-3895-372-34
(1) Aline plate (17, fig. 2-7) with frame and install two bolts (19), two flat washers (10), two lockwashers (12), and two
nuts (15). Do not tighten.
(2) Aline bracket (11) with plate (17) and install two bolts (9), four flat washers (10), (one washer on both sides of
brackets), two lockwashers (12) and two nuts (15). Do not tighten.
(3) Secure bracket (3) to pump (1) with two bolts (23) and two lockwashers (22).
(4) Install key (2).
(5) Install bushing (5) in sheaves (4), loosely installing three mounting screws (7) and flat washers (6).
(6) Line up bushing (5) with key (2) on pump shaft and slide sheaves on the pump shaft until resistance is felt. Do not
tighten screws.
(7) Install bushing (8) with three screws (7), and flat washers (6).
(8) Aline two spacers (20) with plate (17).
(9) Install pump (1) with bracket (3) on vehicle, installing and tightening the four mounting bolts (21) and lockwashers
(12).
(10) Aline the sheaves. (Refer to TM 5-3895-372-20.)
(11) Tighten the three screws (7) and flat washers (6) to bushing (5) and sheaves (4).
(12) Install six drive belts (1, fig. 2-6). Make sure pump is all the way toward the center of the vehicle.
(13) Install two nuts (14, fig. 2-7) on lockscrews (13) and insert lock screws through holes on frame. Install four nuts
(16) on lock screws and insert the lock screws through the holes in plate (17).
Install two nuts (18)
on the end of the lock screws (13).
(14) Adjust the belts (1, fig. 24). (Refer to TM 5-3895-372-20.)
(15) Before installing caps (5 and 6, fig. 2-5), install new O-rings.
(16) Install return line with relief valve and bypass line attached. Torque four screws (4) to 28 Ib-ft (38 N-m).
(17) Change the oil filter element (7). (Refer to TM 5-3895-372-10.)
(18) Install oil filter assembly (8) with piping attached. Torque four screws (3) to 68 Ib-ft (92 N-m)
(19) Install oil filter inlet hose (2) and tighten swivel nut (1).
(20) Fill oil reservoir. (Refer to LO 5-3895-372-12.)
(21) Start engine and engage PTO. (Refer to TM 9-2320-273-10.)
(22) Operate mixing auger, (refer to TM 5-3895-372-10) and check for leaks. Correct any leaks that are found
2-21