TM 5-3895-372-34
(2)
Start coating one or two threads from the small or leading edge of the plug.
(3)
Torque the pipe plugs to their specified torque. Do not use power tools.
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
2-12. Introduction. This section provides you with procedures for replacing major component parts of the mixer body.
Organizational level replacement procedures described in TM 5-3895-372-20 are not repeated. Following is a list of
replacement procedures given in this section.
a.
Oil pump
b.
Sand and Stone Bin Assembly
c.
Main Clutch
d.
Cement Feeder
e.
Cement Bin Assembly
2-13.
Hydraulic Oil Pump.
a.
Removal.
(1)
Raise and prop access door in the open position.
(2)
(3)
Loosen setscrew (1) and remove tachometer cable and bracket.
TA076111
Figure 2-4. Removal of Tachometer Cable and Housing.
2-17