TM 5-3895-359-14&P
STEERING GEAR REPLACEMENT
STEERING GEAR
REMOVAL
FRONT AXLE REPLACEMENT
1. Remove screws (1), steering cap (2) and nut (3).
REMOVAL
2. Use a suitable puller and remove steering wheel
(4), from splined shaft of steering column (5).
1. Place jack stands under mixer front frame
3. Label, disconnect and cap hydraulic steering
behind front axle.
lines (6), (7),(8),(9).
2. Remove both front wheels.
4. Remove U-bolt (10) from steering column
bracket (11).
3. Disconnect the steering cylinder from the axle at
both ends and remove with hydraulic lines attached.
5. Remove four bolts, nuts, washers (12) that
attach bracket (13) to firewall of vehicle. The steering
4. Place lifting sling around axle.
column and valve can now be removed from the engine
5. Remove axle pivot pin.
side of the firewall.
6. Remove axle assembly and place in suitable
area for repair.
The steering gear is not repairable and if replacement is
necessary, it must be replaced as a unit.
INSTALLATION
INSTALLATION
Installation is the reverse procedure.
Installation is the reverse procedure.
11-7
