TM 5-3895-372-10
Figure 3-30. Check Wear Blade Wear.
3-19. Mix Auger Test.
NOTE
Up and down movement of hydraulic motor is usually caused by a bent auger shaft. The operator
can visually check for a bent shaft by following these steps:
a. Operate the mixer auger (empty) at a low RPM.
b. Closely watch the hydraulic motor (fig. 3-31).
c. If the movement of the motor, up and down or side to side exceeds one-eighth inch, notify Organizational
Maintenance.
TA 075577
3-76
