F-6. THREE-PIN
TM 5-3895-369-14
NOTES-
1.
FABRICATE FROM THE FOLLOWING MATERIALS:
ONE M17136-1, MS51967-35 1-1/4 IN. HEX NUT.
ONE M17136-2, 1/4 IN. x 3 IN. OUTSIDE DIAMETER, COLD ROLLED STEEL.
ONE M17136-3, 3 IN. OUTSIDE DIAMETER x 2-1/2 IN. INSIDE DIAMETER, COLD ROLLED STEEL PIPE X 4 IN. LONG,
ONE M17136-4 DRIVE PIN PLATE (SEE FIGURE F-3).
THREE M17136-5 DRIVE PINS (SEE FIGURE F-4).
UNSAFE WELDING PRACTICES CAN CAUSE SERIOUS INJURY FROM FIRE, EXPLOSIONS, OR HARMFUL AGENTS.
ALLOW ONLY AUTHORIZED PERSONNEL TO WELD OR CUT METALS, AND FOLLOW SAFETY PRECAUTIONS IN TM 9-237.
PROTECTIVE CLOTHING AND GOGGLES MUST BE WORN; ADEQUATE PROTECTIVE EQUIPMENT USED, A SUITABLE
FIRE EXTINGUISHER KEPT NEARBY; AND REQUIREMENTS OF TM 9-237 STRICTLY FOLLOWED.
2.
POSITION AND WELD M17136-1, 1-1/4 IN. NUT TO NUT PLATE Ml 7136-2.
3.
POSITION AND WELD M17136-2 NUT PLATE TO M17136-3 PIPE.
4.
INSERT AND WELD THREE M17136-5 DRIVE PINS IN M17136-4 DRIVE PIN PLATE.
5.
POSITION AND WELD M17136-4 DRIVE PIN PLATE TO M17136-3 PIPE.
6.
ALL DIMENSIONS ARE IN INCHES.
Figure F-5. Three-Pin Face Spanner Wrench
F-6
