TM 5-3895-369-14
5-22. PISTON AND CONNECTING ROD REPLACEMENT/REPAIR (CONT).
(5) Tighten 12 screws (1) in pattern shown and
in following steps:
(a) Step 1: 26 lb-ft (35 Nm).
(b) Step 2: 51 lb-ft (70 Nm).
(c) Step 3: 73 lb-ft (100 Nm).
(6) Measure side clearance between connecting
rod and crankshaft as indicated. Side
clearance limits are 0.004 to 0.012 in. (0.1 -
0.3 mm), If measurement is above or below
limits, loosen screws (1), check connecting
rod, and reinstall or replace. If
measurement is still out of limits, check
crankshaft (refer to para 5-14).
NOTE
Follow-on maintenance:
Install cylinder head assembly (para 5-12).
Install engine oil pan and suction tube (para 5-29).
END OF TASK
5-168