TM 5-3895-369-14
4-180. STORAGE INSTRUCTIONS (CONT).
(j)
Allow excess preservative oil to drain from chain, then coat chain with P-l preservative oil (item 42,
(k) Install additive coupling guard (para 4-153).
(l)
Secure supply hose boom to vehicle (para 2-12).
(14) Prepare rotor system for long term storage:
(a) Lower rotor to ground (Figure 2-1).
(b) Lower tailboard completely (Figure 2-1).
Coat unpainted rotor parts with P-l preservative oil (item 42, appendix E).
(c)
(d) Coat exposed area of boom cylinder piston rod with P-6 or P-11 preservative oil (item 43 or 46
(e) Cover exposed area of boom cylinder piston rod with barrier material (item 28, appendix E). Barrier
material should extend about two inches up on cylinder.
Secure barrier material in place with tape (item 56, appendix E).
(f)
(g) Coat exposed area of tailboard cylinder piston rod with P-6 or P-11 preservative oil (item 43 or 46,
(h) Cover exposed area of tailboard cylinder piston rod with barrier material (item 28, appendix E).
Barrier material should extend about two inches up on cylinder.
Secure barrier material in place with tape (item 56, appendix E).
(i)
(15) Prepare instrument panel or long term storage:
(a) Remove front and rear floodlights (para 4-81).
(b) Box lights individually with boxes (item 3, appendix E).
(c) Secure boxes to vehicle.
(16) Prepare instrument panels for long term storage:
(a) Install instrument panel covers (para 4-73).
(b) Seal edges between instrument panels and covers with tape (item 56, appendix E).
(c) Wrap vacuum gauge with barrier material (item 27, appendix E).
(17) Coat inside of ignition switch with preservative oil (item 44, appendix E).
(18) Coat unpainted surfaces of hydraulic control levers with Type P-l preservative oil (item 42, appendix E).
4-570
