TM 5-3895-369-14
(3) Remove four nuts (7), lockwashers (8),
screws (9), and adapter (10) from pillow
block assembly (4). Discard lockwashers.
(4) Remove four nuts (11), lockwashers (12),
and mounting bracket (13) from pillow
block assembly (4). Discard lockwashers.
(5) If damaged, remove four studs (14).
b. Installation.
(1) If removed, install four studs (14).
(2) Install mounting bracket (14) over studs (13)
on pillow block assembly (4) with
lockwashers (12) and nuts (11). Tighten
nuts 75 to 85 lb-ft (102 - 115 Nm).
(3) Install adapter (10) on pillow block assembly (4) with four screws (9), lockwashers (8), and nuts (7).
Tighten nuts 75 to 85 lb-ft (102 - 115 Nm).
(4) Position plate (6) on top of axle (5).
(5) Install pillow block assembly (4) on axle (5)
with four screws (3), lockwashers (2), and
nuts (1). Tighten nuts 150 to 160 lb-ft
(203 - 217 Nm).
NOTE
Follow-on Maintenance:
Install PTO drive shaft (para 4-101).
Install clutch drive shaft (para 4-102).
END OF TASK
4-373