TM 5-3895-359-14&P
DISASSEMBLE DRIVE UNIT
DISASSEMBLE DIFFERENTIAL AND
1. Carefully centerpunch rivets in center of head.
GEAR ASSEMBLY
2. Use drill '1,2t" smaller than body of rivet to drill
through head.
3. Press out rivets.
A. If original identification marks are not
clear, mark differential case halves with a
punch or chisel (as shown in photograph
above) before disassembling, for correct
alignment when reassembling.
E. Remove differential bearings with bearing
B. Cut lock wire, remove bolts or cap screws
puller if necessary to replace.
and separate case halves.
C. Remove spider, pinions, side gears and
REMOVE PINION AND CAGE ASSEMBLY
thrust washers.
The differential and gear assembly must be removed
D. Remove rivets and separate gear and
before the pinion and cage assembly can be
case if required.
disassembled.
A. Secure yoke with holding tool and remove
pinion shaft nut and washer.
5-12
