TM 5-3895-342-34
c.
Cleaning, Inspection and Repair.
assembly in reverse of numerical sequence as illustrated
in figure 3-8.
(1) Clean all parts with a cleaning solvent.
e. Installation. Install the clutch assembly in
(2) Inspect all parts for wear and damage.
reverse of the instructions in subparagraph above.
Repair or replace worn or damaged parts.
d. Reassembly.
f.
Adjustment. Adjust the clutch assembly (TM 5-
Reassemble the clutch
3895-342-121.
Section II. ENGINE COMPONENTS
(2) To check stator, rectifier module and
3-8. General
regulator module, refer to table 3-1. Replace defective
This section provides information on the maintenance of
components.
those items which are considered engine components.
c. Installation. Install the flywheel alternator in
They consist of the flywheel alternator, cylinder heads,
reverse of the instructions in subparagraph a above.
timing gears, oil pump, connection rod and piston
CAUTION: The following are precautions to be
assemblies, crankshaft assembly, camshaft and valve
(1) Do not reverse battery connections. This
3-9. Flywheel Alternator
is for a negative ground system only.
a. Removal
(2) Connect booster batteries properly-
(1) Remove the flywheel (TM 5-3895-342-12).
positive to positive and negative to negative.
(2) Disconnect the 14 gage green wire from
(3) Do not polorize the alternator.
(4) Do not ground any wire from stator or
(3) Disconnect the rectifier module leads at
modules which terminate at connectors.
the terminal block plug and receptacle. Remove the two
(5) Do not operate engine with battery
disconnected from system.
module to the engine.
(6) Disconnect at least one battery lead if a
(4) Disconnect the regulator module leads at
fast battery charger is used.
the terminal block plug and receptacle. Remove the two
(7) Never use a fast battery charger to boost
the battery output.
module shield and regulator module to the engine.
(5) Remove the two roll pins and four screws
3-10. Cylinder Heads
and lockwashers securing the stator to the engine.
a.
Removal.
b. Cleaning, Inspection and Repair.
(1) Remove cylinder air shrouds (TM 5-3895-
(1) Wipe all parts with a clean dry rag.
342-12).
(2) Remove spark plugs (TM 5-3895-342-12).
3-13