TM 5-3895-342-34
Note. Scribe mark the position of both the end bell
continuity is indicated, the commutator end frame is
and the starter gear housing on the frame and field
defective and must be replaced.
assembly so they can be assembled in the same
(5) Replace worn or damaged parts.
position.
d. Reassembly. Reassemble the starting motor
Note. Due to the method of installing field coils in
in reverse of numerical sequence as illustrated in figure
this unit, it is necessary that the complete frame and field
assembly be replaced if field coils are required.
e. Installation. Install the starting motor (TM 5-
3895-342-12).
c.
Cleaning, Inspection and Repair.
(1) Clean all parts with a cleaning solvent.
3-6. Clutch Housing Assembly
(2) Inspect all parts for wear and damage.
a. Removal Remove the clutch housing assembly
(3) Test the armature on a growler for shorts,
open circuits, and grounds.
Replace a defective
b. Disassembly. Disassemble the clutch housing
armature.
assembly in numerical sequence as illustrated in figure
continuity and ground. Replace a defective field coil.
insulated brush holder and the commutator end frame. If
3-9