TM 5-3895-369-14
(2) Clean sealing surfaces.
(3) Check machined surfaces for damage.
(4) Replace damaged parts.
d. Assembly.
(1) If removed, install two bushings (8) in tie
rod ends (5).
(2) Install two grease fittings (7) in tie rod
ends (5).
(3) Install clamps (3), screws (2), and nuts (1) on
tube (6). Do not tighten.
(4) Install tie rod ends (5) in tube (6) until
measurement recorded during disassembly is
reached. Tighten nuts 70 lb-ft (95 N-m).
Installation.
e.
(1) Install tie rod (4) in steering knuckles (3).
(2) Install two pins (2) and cotter pins (1) on each steering knuckle (3). Tighten nuts 70 lb-ft (95 Nm).
NOTE
Follow-on Maintenance:
Install front right wheel (para 4-115).
l
l
Lubricate fittings (figure 3-l).
END OF TASK
5-441