TM 5-3895-369-14
(5) Install grease fitting (13) in slip yoke (4).
(6) Install grease fitting (12) and position four
grease seals (7) on universal joint (8).
(7) Position universal joint (8) in flange
yoke (10) and slip yoke (4).
Be careful when installing bearing caps.
Needle bearings may fall out and be
damaged or lost.
(8) Apply grease to insides of four bearing
caps (11) and install in slip yoke (4) and
flange yoke (10).
(9) Install four clips (9) and slide four grease seals (7) into place.
(10) Position cover (1), split ring (6), and cork
seal (5) on spline shaft (2) of drive shaft (3).
(11) Align matchmarks and install slip yoke (4)
on drive shaft (3) and tighten cover (1).
NOTE
Follow-on Maintenance: Install pump drive shaft (para 4-100).
END OF TASK
5-360