TM 5-3895-359-14&P
REASSEMBLE PLANETARY SPIDER ASSEMBLY
A. Place the spider in a press with the flange side up. Block up as required.
B. Install inner thrust washer with the rasher tab engaged in the spider indent and the washer bore aligned with the
spider bore.
C. Coat the bore of the planet gear with a film of the same GL-5 gear lube used in the wheel end. Slide planet gear
and outer thrust washer into the spider. Align the bores of the parts and engage the outer thrust washer tab in
the spider Indent.
D. Install the planet pin into the spider and through the planet gear and thrust washers by hand. The large end of
the planet pin will bind in the spider bore due to an Interference fit.
E. Align the small mark on the pin large diameter
with the mark on the spider. These match
marks are pre-stamped into the parts to provide
proper alignment of the set screw hole in the
small end of the pin and the tapped set screw
hole in the spider boss
5-6