TM 5-3895-359-14&P
The tapered bearing can be pressed off the shaft if
required. Be careful not to damage the seal diameter of
the shaft while removing the bearing.
From this point on it is necessary to mark all parts so
that neutral (zero swashplate angle) will be retained
when the parts are reassembled. The swashplate is
held in neutral by springs inside the servo housings.
These springs are adjusted by turning the servo
housings.
First, mark the servo housing for location to the pump
housing. This set of marks should line up to show the
rotational position of the servo housing to the pump
housing.
Remove the locking retainers using a 12 point, 3/16
socket for the cap screws.
6-37
