TM 5-3895-359-14&P
COMMON SERVICE PROBLEMS (Cont.)
Problem
Remedy
HARD PEDAL
1.
Worn pedal linkage.
1.
Replace with new linkage.
2.
Binding in pedal linkage.
2.
Iubricate and adjust.
3.
Excessive spring pressure in cover ass'y,
3.
Install proper cover ass'y.
4.
Contact pad of release bearing carrier worn bv
4.
Replace carrier and shifter yoke. Also check
shifter yoke.
for proper hook-up to provide best linkage oper-
ating positions.
SLIPPAGE
1. Oil or grease on facing.
1. Replace facing or install new driven disc
ass'y. and correct oil leak.
2. Loose or worn facings.
2. Replace facings or install new driven disc
ass' .
y
3.
Flywheel burned, checked or cracked,
3. Replace or regrind.
4.
Insufficient plate pressure.
4. Install new cover assembly.
5.
Binding in pedal linkage.
5. Lubricate and adjust.
6.
Improper facing material.
6. Use correct facing or replace disc ass'y.
VIBRATION
1. All or part of power train out of balance.
1. Check each unit individually and recheck as a
complete ass'y.
2. One or more units in power train out of align-
2. Check and align (replace faulty component).
ment.
3.
Worn splined shaft.
3. Replace.
4.
Worn crankshaft bearings.
4. Replace.
5.
Worn or loose engine mounts.
5. Replace or tighten.
6.
Loose or out of balance universal joint.
6. Tighten or replace - check for balance.
7.
Clutch out of balance
7. Install balance unit.
8.
Worn disc splines.
8. Replace disc.
SUMMARY OF PROBLEMS AND SOLUTIONS - Generally if the flywheel, engine mounts, transmission shaft, and
power train are all installed properly: and operating correctly, then the correct clutch, properly installed, until do the job in
the vehicle.
4-5
