TM 5-3895-342-12
(6) Remove belt guard (fig. 4-5). Install
hoist drive belts (packed in tool box) as instructed
on figure 4-6. Install pump drive belt packed in tool
box) as instructed on figure 4-7.
1. LOOSEN NUTS (4) AND MOVE PUMP JUST
FAR ENOUGH TO PERMIT SLIPPING BELT
INTO PLACE ON SHEAVES.
2. MOVE PUMP TO ADJUST BELT TENSION
THEN TIGHTEN NUTS (4). CORRECT BELT
TENSION IS 1/2 INCH DEFLECTION
MIDWAY BETWEEN SHEAVES.
ME 3895-342-12/4-7 C1
Figure 4-5. Belt guard removal.
Figure 4-7. Pump drive belt installation and
adjustment.
(7) Remove fire extinguisher from tool box on
mixer and install as instructed on figure 4-8.
1. LOOSEN UPPER AND LOWER NUTS ON
ADJUSTING ROD.
2. PRY ENTIRE MECHANISM HIGH ENOUGH
TO PERMIT SLIPPING BELTS INTO PLACE
ON SHEAVES.
3. ADJUST BELTS AT ADJUSTING ROD.
CORRECT BELT TENSION IS 1/2 INCH
DEFLECTION
MIDWAY
BETWEEN
SHEAVES.
ME 3895-342-12/4-6 C1
Figure 4-8. Fire extinguisher installation.
Figure 4-6. Hoist drive belts installation and
adjustment.
Change 1 4-2
