LO 5-3895-219-12
-KEY-
EXPECTED TEMPERATURES
Above +15 F
+ 40 F to -15 F
+40 F to -65 F
CAPACITY
INTERVALS
(Above -9 )
(+ 4 to -26 )
(+4 to -54 )
C/MR-
CW - Lubricating
Condition
(GRADE 11B)
Oil, Chain,
Monitor
ALL TEMPERATURES
Wire Rope,
Exposed
Intervals
Gear
given are
GAA - Grease,
Automotive
in hours
and Artillery
ALL TEMPERATURES
of normal
operation.
*See Note 12 for lubricant specification number.
NOTES:
1.
FOR OPERATION OF EQUIPMENT in
5.
ENGINE OIL FILTER (CONTINENTAL MODEL
YS116). Each 100 hours, remove filter element, clean
PROTRACTED COLD TEMPERATURES BELOW -15F
housing and install new filter element. After installing
(-26C).
Remove lubricants prescribed in Key for
new filter element, fill crankcase, operate engine for 5
temperatures above -15F (-26C). Relubricate with
minutes, check housing for leaks, check crankcase oil
lubricants specified in Key for temperatures below 15F
level and bring to "FULL" mark.
(-26C).
If OEA lubricant is required to meet the
temperature ranges prescribed in the Key, OEA lubricant
6. ENGINE OIL (WISCONSIN MODEL MVF4D). Oil is
is to be used in place of OE/HDO-10 lubricant for all
to be changed each 50 hours. Drain when lubricant is
temperature ranges where OE/HDO-10 is specified in
warm.
the Key.
7.
ENGINE OIL FILTER (WISCONSIN MODEL
2. OIL CAN POINTS. Each 50 hours clean and lightly
MVF4D). Each 50 hours, remove filter element, clean
coat the governor control linkages, and control linkage
housing and install new filter element. After installing
and all exposed adjusting threads with OE/HDO.
new filter element, fill crankcase, operate engine for 5
Weekly clean and lightly coat the governor and
minutes, check housing for leaks, check crankcase oil
carburetor linkage and joints for the Wisconsin model
level and bring to "FULL," mark.
MVF4D engine with OE/HDO.
8. AIR CLEANER. Each 10 hours, refill reservoir to
3. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold
level mark. Each 50 hours, disassemble entire unit,
engine, oil level should be at high mark on dipstick. Hot
clean, re-oil and assemble.
engine, oil level must be between high and low marks on
dipstick (allow to set 5 minutes before checking).
9. DRIVE CHAIN GUARD/GEAR HOUSING. Check
level each 250 hours. Change gear lubricant only when
4. ENGINE OIL (CONTINENTAL MODEL YS116). Oil
is to be changed each 100 hours. Drain when lubricant
water, or other foreign material. After refill, operate for
is warm.
five minutes,
TA 220611
CARD 7 OF 8