TM 5-3895-372-34
t.
Remove three cotter pins (30) on yoke (31).
NOTE
Exercise care as levers (28) are under tension of lever springs (29).
u.
Cup your hand over six levers (28), six rollers (27), three lever springs (29), and remove three lever pins (32).
v.
Remove levers (28), rollers (27), and lever springs (29) from yoke (31).
6-19.
Clean and Inspect. Clean all parts in dry cleaning solvent and inspect for damage or wear.
6-20.
Assemble.
a.
Position six levers (28), rollers (27), and three lever springs (29) onto yoke (31); install three lever pins (32).
b.
Lock lever pins (32) in place with cotter pins (30).
c.
Press shaft (1, fig. 64) into driving spider hub (3) and tighten setscrew (2).
d.
Press shaft (15) thru hub plate (8) and bearing %25); tighten setscrew (7).
e. Install hub plate (8) into driving spider hub (3). Install driving ring (4), six washers (5) and capacrews (6).
Tighten capscrews securely.
f.
Install four springs (23) and pins (24) and hub plate (8). Tighten setscrew (7).
g.
Install three section driving clutch plate (9), floating plate (10) and roller disk (11).
h.
Place yoke assembly (12) in separate cover (13) and install three machine screws (14) and tighten.
i.
Press bearing (18) onto cone (21) and install snapring (17).
j.
Press bearing (18) and cone (21) into collar (16).
k.
Install cone snapring (20).
I.
Place lockpin (33, fig. 6-6) and spring (34) in position, pull pin out and install wire to hold it out.
m.
Install separate cover (13) and yoke assembly (12) by turning clockwise.
n.
o. Install bearing blocks (1 and 9) and locking collars (10). Aline locking rings with punch marks and tighten
setscrews (6).
p.
6-21.
6-12