TM 5-3895-369-14
(16)
Measure shaft end play at position B.
Normal measurement is 0.001 to 0.003 in.
(0.03 - 0.08 mm). If measurement is not
within limits, replace thrust collar and
turbine shaft.
(17)
Measure radial clearance at position C.
Normal measurement is 0.012 to 0.018 in.
(0.30 - 0.46 mm). If measurement is not
within limits, replace bearings. If
measurement is still not within limits,
replace bearing housing.
(18)
Install preformed packing (5) in compressor housing (4).
(19)
Assemble compressor housing (4) on diffuser (6) and tighten clamp (3) 50 lb-in (5.7 N•m). Tap around
clamp with plastic hammer and tighten clamp again at same value.
(20)
If removed, install data plate (2) with two rivets (1).
N O T E
Follow-on Maintenance: Install turbocharger (para4-44).
END OF TASK
5-281
