TM 5-3895-369-14
( 4 )
Position heat shield (19) on bearing
housing (16).
N O T E
Rotating turbine shaft in assembly will
properly seat split ring.
Scribe mark on impeller end of turbine
shaft and oil baffle must be aligned to
ensure balance of turbine shaft. Failure to
do so will result in damage to
turbocharger.
(5)
Install split ring (18) on turbine shaft (7) and assemble turbine shaft and bearing housing (16). Ensure that
scribe marks on turbine shaft and oil baffle (20) are aligned.
(6)
Align scribe marks and install bearing housing (16) and turbine shaft (7) as an assembly in turbine
housing (17).
Adhesive causes immediate bonding on contact with eyes, skin, or clothing and also gives off harmful
vapors. Wear protective goggles and use in well-ventilated area. If adhesive gets in eyes, try to keep eyes
open; flush eyes with water for 15 minutes and get immediate medical attention.
(7)
Apply anti-seize compound on threads of four screws (14).
(8)
Install two lockplates (15) with four screws (14). Tighten screws 100 lb-in. (11.3 N•m).
5-279
