TM 5-3895-359-14&P
NOTE:
otherwise the oil flow will be reversed and could
The copper washer must be installed on the second
result in foreign particles that may not have been
bolt from the bottom of the oil cooler adaptor to
removed to be loosened and circulated through the
prevent leakage of oil from the adaptor.
engine.
3.
Set the housing with the cooler core against the
2.
Affix new gaskets and to each side of the core
and position the core inside the housing.
adaptor and secure with bolts and lock washers, at the
same time locating the seal and clamp. Tighten the
clamp (Fig. 1).
NOTE:
The inlet and outlet openings in the oil cooler core
4.
Affix a new gasket to the oil cooler water inlet
are marked "IN" and "OUT". Make sure the oil
connector and secure with bolts and lock washers.
cooler core is reinstalled in its original position,
10-5-18