TM 5-3895-359-14&P
2.
Insert a clean, lintless cloth in the flywheel
a. Affix a new gasket to the mounting flange on the
housing opening to prevent bolts from accidentally
accessory.
falling in the gear train. Align the bolt holes in the
b. Place the pump in position against the flywheel
accessory drive plate with the tapped holes in the
housing; rotate it, if necessary, to align the teeth
balance gear. Then secure the plate with four bolts.
of the driven hub with those in the drive
coupling. Then secure the pump to the flywheel
3.
Install the drive coupling (Fig. 1) and proceed as
housing with bolts and lock washers.
follows:
10-2-129