TM 5-3895-359-14&P
An alternate method of installing this bearing is to use the bearing puller bar and
press the bearing onto the shaft with the center screw of the puller bar. A spacer
must be used between the center screw and the bearing.
The bearing must be pressed on until it rests on the shoulder of the shaft to
insure adequate bearing clearance.
Install the pilot ring in the bearing plate and the locating pin in the cylinder block.
Install the bearing plate so that the milled slot locates over the pin and the pilot
ring fits in the center bore of the cylinder block. After installation, lubricate the
exposed surfaces with clean hydraulic oil.
Assemble the bearing race, shim (if required) and locating pin in the end cap.
Check the valve plate to be certain it is a pump valve plate (has 2 tapered slots)
and that it is for correct rotation (slots point away from direction of rotation).
6-47
