TM 5-3895-359-14&P
Assemble the bearing race shim (if required) and
locating pin in the end cap. Lubricate the end cap face
with clean hydraulic oil. Install the valve plate so that
the milled slot locates over the pin and the center bore
fits over the protruding bearing race. Check the valve
plate to be certain it is a motor valve plate (has 4
tapered slots).
Place the end cap gasket on the housing, being certain
the locating pins are in place, then install the end cap
and valve plate. Hold the valve plate so it does not drop
off during assembly. The end cap and gasket will only
align with housing mounting holes in one position.
Install two (2) end cap screws and alternately tighten
them until the internal spring has compressed far
enough for the end cap to rest on the housing. Install
the remaining screws.
Install the shaft seal and valve manifold as outlined in
the In-Warranty repair procedures.
Fill the motor housing with clean hydraulic oil.
6-31