TM 5-3895-359-14&P
Special Tools
Certain tools are required that are not normally carried which are as follows:
1. Waldes Truarc # 7 Retaining Ring Pliers
2. Torque Wrench
3. Tapered Bearing Puller
Ref. Snap On Part Numbers
Puller Bar CG350
20-23- Series: Separator CJ950
24-27 Series: Separator CJ951
Remove the shaft seal as outlined under Minor repair procedures. The shaft
seal must be removed before end cap screws are loosened to prevent the
seal being damaged.
NOTE:
The end cap screws should not be loosened until the shaft seal
has been removed.
Remove the valve manifold assembly as outlined under Minor repair
procedures.
Remove all but two (2) of the hex head screws holding the end cap to the
housing. Make sure the two remaining screws are opposing each other.
There is an internal spring loading on the end cap and as the last two (2)
screws are loosened, it should begin to separate from the housing. Loosen
these screws alternately until the end cap has fully separated from the
housing, then remove the screws entirely.
6-24
