TM 5-3895-359-14&P
(l) Install yoke bar seal (item 40) and
retainer (item 41).
hole-and through sliding gear. Drive rear section of
(m) Install case cover (item 15) and
shaft and bearing into case bearing bore.
tighten screws evenly, and securely.
(n) Install mainshaft spacer (item 28),
(e) Install rear bearing cover oil seal
universal joint flange, washer (item 43) and nut (item
(item 30) and mount bearing cover (item 29) on case,
44). Cotter key nut, after tightening.
tightening cap screws (item 42) evenly and securely.
(f) Drive pilot bearing (item 22) on end
of front section of main shaft. Pre-lubricate bearing.
CAUTION
(g) Drive main drive gear assembly
The mainshaft is held in its proper
(item 11) into case from front.
place by the companion flange. The
omission of parts between flange
(h) Install shifting yoke (item 24) and
and bearing or failure to pull flange
yoke bar (item 25).
tightly into place will allow mainshaft
(i) Install shifting yoke lock screw and
to move endwise with resultant
safety wire.
damage to pilot bearing, main drive
(j) Install poppet ball (item 18), tension
gear, and rear bearing cover.
spring (item 19) and tension spring spacer (item 20).
(k) Install flat cover (item 21).
4-11
