TM 5-3895-342-12
Table 3-1. Operator/Crew Preventive Maintenance Checks and Services-Continued
Interval
ITEM TO BE INSPECTED
Item
Procedure: Check for and have repaired,
Equipment is not ready/
No.
B
D
A
W
M
filled, or adjusted as needed
available if:
4
CONTROLS (Check for proper operation)
a. Governor (1600 RPM) and choke control.
Governor does not control.
b. Handwheel
Broken or will not operate.
c. Water valve.
Broken or will not operate.
d. Clutch and brake lever.
Broken or will not operate.
5
INSTRUMENTS (Check for proper indication)
a. Engine oil pressure gauge-Green range normal operation.
Engine oil pressure gauge or
b. Ammeter-Green range normal operation.
c. Hour Meter/Tachometer-1600 RPM normal operation.
operation.
d. Water gauge.
6
DRUM
Use a hose and brush and clean mixer thoroughly, both
inside and outside of drum.
7
BELTS
Inspect generator, hoist, and pump drive belts for
Belt missing or broken.
frayed or cracked condition.
8
HOIST CABLE
Inspect cable for broken, kinked, or flattened strands.
Cable is broken, obviously
Check for obvious wear, corrosion or abrasions.
worn or corroded
9
AIR CLEANER
Inspect the air cleaner bowl for dirt and improper oil level.
Clean the bowl if dirty and fill with oil to indicated level.
10
BATTERIES
Check level of electrolyte. If low, fill with clean water (distilled
if possible) to the split ring. In freezing weather, run
engine at least 15 minutes after adding water.
11
TIRES
a. Check for cuts and general condition.
b. Check for correct air pressure (50 PSI).
Change 2
3-2.1