LO 5-3820-242-12
* KEY -
-
EXPECTED TEMPERATURES
Above +15 F
+40 F to -15 F
+40 F to -65 F
CAPACITY
INTERVALS
(Above -9 )
(+4 to -26 )
(+4 to -54 )
OE/ - Lubricating
OE/HDO
30
OE/HDO
10
HDO
Oil, Internal
Engine,
Tactical
Service
OEA - Lubricating Oil,
OEA
Internal
(See Note 1)
Arctic
- Oil Can Points
(See Note 2)
- Engine
5 1/2 qts.
(5.2 L)
Intervals
- Power Take-
3/4 qt..
off
(0.7 L)
given are
- Chaincase
3/4 qt.
in hours
(0.7 L)
- Air Cleaner
3/4 qt.
of normal
(0.7 L)
operation.
CW
- Lubricating
CW II B
CW II A
CW II A
Oil,
Chain
Wire
Rope
Exposed Gear
GAA - Grease,
ALL TEMPERATURES
Automotive
and Artillery
* See Note 9 for lubricant specification number.
NOTES:
1.
FOR OPERATION OF EQUIPMENT IN
3. WHEEL BEARINGS. Each 1,000 hours, remove
wheels, clean and inspect all parts, replace damaged or
PROTRACTED COLD TEMPERATURES BELOW -15F
worn parts, repack bearings, and assemble.
(-26C).
Remove lubricants prescribed in Key for
temperatures above -15F (-26C). Relubricate with
4. POWER TAKEOFF CHAINCASE. Check level each
lubricants specified in Key for temperatures below -15 F
10 hours. Each 100 hours change oil. Drain when
(-26C).
If OEA lubricant is required to meet the
lubricant is warm.
temperature ranges prescribed in the Key, OEA lubricant
is to be used in place of OE/HDO-10 lubricant for all
5. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold
temperature ranges where OE/HDO-10 is specified in
engine, oil level should be at high mark on dipstick. Hot
the Key.
engine, oil level must be between high and low marks on
dipstick (allow to set 5 minutes before checking
2. OIL CAN POINTS. Each 50 hours lubricate throttle
and governor linkage, all hinges, pins, devises and
exposed adjusting threads with OE/HDO.
TA 220411
CARD 5 OF 6
