The temperature of the engine coolant is automatically
water to form sulfuric acid. Therefore, install a
controlled by a thermostat located in a housing
180 r 190 (82 r 88 ) temperature thermostat
connected to the outlet end of the water manifold. A
and modify the cooling system to provide rapid
blocking type thermostat (Fig. 1) is used in the standard
warm-up in order to maintain coolant temperature
at a minimum of 175 (80 ).
At coolant temperatures below approximately 160 to
1. Drain the cooling system to the necessary level by
170 (71 to 77 ), the thermostat valves remain
opening the drain valve.
closed and block the flow of coolant to the radiator.
2. Remove the bolts which secure the outlet elbow and
During this period, all of the coolant in the standard
the thermostat housing (bypass tube) to the water
system is circulated through the engine and is directed
back to the suction side of the water pump via the
bypass tube. As the coolant temperature rises above
3. Remove the thermostat and clean the seat for the
160to 170F (71to 77C) the thermostat valves start
thermostat in the outlet elbow.
to open, restricting the bypass system, and permit a
portion of the coolant to circulate through the radiator.
4. Remove and discard the seals pressed in the water
When the coolant temperature reaches approximately
185 to 195 (85 to 91 ) the thermostat valves are
fully open, the bypass system is partially blocked off,
and most of the coolant is directed through the radiator.
If the action of the thermostat has become impaired due
to accumulated rust and corrosion from the engine
A properly operating thermostat is essential for efficient
coolant so that it remains closed, or only partially open,
operation of the engine.
If the engine operating
thereby restricting the flow of coolant, overheating of the
temperature deviates from the normal range of 160 to
engine will result. A thermostat which is stuck in the
185 (71o 85 ) or 170 to 195 (77 to 91 ),
wide open position may not permit the engine to reach
remove the thermostat and check it.
its normal operating temperature.
combustion of fuel due to cold operation will result in
CAUTION: There are areas where
build-up of carbon deposits on the pistons, rings and
approved fuel (less than 0.5% sulfur)
is not commercially available or
economically feasible to obtain. It is
Check the operation of a thermostat as follows:
important to keep the engine cooling
system temperature of these engines
1. Immerse the thermostat in a container of water (Fig.
on the high side of normal to prevent
2. Place a thermometer in the container using care not
to allow the thermometer to touch the bottom or sides of
3. While slowly agitating the water to maintain an even
temperature, apply heat to the container. As the water
is heated, the thermostat should begin to open (the
opening temperature is usually stamped on the
thermostat). The thermostat should be fully open at
approximately 185- 195 (8591 C). Allow at least
10 minutes for the thermostat to react.
Fig. 1 - Typical thermostat Housing Mounting
(Radiator Cooling System)