SUBSECTION 2 EMULSION PUMP AND WASH
e. Deform seal (E) and remove from body
cavity. Do not tamper with or disassemble motor.
Before performing service on wash
down pump disconnect in-line fuse
a. Lubricate seal (E). Deform seal and
on orange wire from pump. Fig. 2
install in cavity with open side of seal facing impeller.
b. Lubricate motor shaft and install pump
body on motor.
c. Lubricate impeller bore. Align "flat" in
impeller bore with "flat" on impeller shaft, install
d. Install gasket, end cover and screws.
SERVICE INSTRUCTIONS FOR WASH DOWN PUMP
a. Remove screws (A), cover (B) and gasket
b. Withdraw impeller (D).
c. Loosen and remove two slotted screws
(H) holding pump body (G) to motor (K).
d. Tap pump body lightly between ports and
remove body from motor.