TM 5-3895-372-10
(2) Turn the handwheel until the pointer shows the stone dial setting you have been given. Always adjust the
pointer upwards
(3) Tighten the stopscrew.
NOTE
When setting dials to a lower setting, it may become necessary to "slip" the main clutch which will
actuate the conveyor belt slightly. This procedure will prevent stones or sand from binding the
aggregate gates.
g. Set Meter Register to Zero. (See fig. 2-35.)
CAUTION
Never reset the meter register while it is operating.
Turn the reset knob until it comes to a full stop,
Push in on the reset knob. Turn It clockwise until It stops. Check that the register reads 0000.0.
2-12. Producing Concrete.
a. Fluff Cement. (See fig. 2-37.) Push the fluffer control valve upward several times. This blows air through the
pads in the cement bin and loosens packed cement.
b. Turn on Chain Oiler. (See fig. 2-38.)
CAUTION
Be sure to turn the chain oiler on whenever the main conveyor is operated. Failure to do so may
cause serious damage to the main conveyor system
(1) Flip lever to mid position to turn chain oiler on.
(2) Check that oil drips at about five drops per minute. Adjust the needle valves as required. Turn in to
decrease flow and turn out to increase flow.
2-49
