TM 5-3895-369-14
5-78. STEERING CYLINDER REPAIR (CONT).
NOTE
Skip step (6) if old piston is being used. If
using unitized piston, go to step (6).
Cap seal can be made more pliable by
warming with hands or placing in hot water
for 5 minutes. Install immediately.
(4)
Install seal (19), seal (18) two back-up ring
seals (17), and wear ring (16) on piston (15).
(5)
Install piston (15) on shaft (13).
(6)
Install locknut (14) on shaft (13). Tighten
locknut 35 to 40 lb-ft (47 - 54 N-m).
(7)
Install shaft (13) in cylinder housing (11).
5-462
